ax_clocks_pinout
Table of Contents
This page is only meant a a guide, it is taken direct from the Haynes Manual but in a more “human” way.
For the switched lives the “Click” on them referes to position on the ignition barrel Under the switched colum, if there is a value (+/-) this is the signal that needs to be applied to get the light to illuminate.
White Connector 10 Pin
| Pin | Function | Switched |
|---|---|---|
| 1 | LH Indicator | + |
| 2 | RH Indicator | + |
| 3 | Ground | |
| 4 | Handbrake On / Low Brake Fluid | - |
| 5 | ABS Light | - |
| 6 | Not Connected | |
| 7 | Switched Live (3rd/4th Click) | |
| 8 | Not Connected | |
| 9 | Illumination -ve | |
| 10 | Illumination +ve | |
Green Connector 9 Pin
| Pin | Function | Switched |
|---|---|---|
| 1 | Oil Pressure | - |
| 2 | Coolent Light | - |
| 3 | Light Below Coolant Guage | - |
| 4 | Coolant Guage | |
| 5 | Cat Light | |
| 6 | Side Lights | + |
| 7 | Dipped Beam | + |
| 8 | Main Beam | + |
| 9 | Glow Plugs (DERV Only) | + |
Yellow Connector 8 Pin
| Pin | Function | Switched |
|---|---|---|
| 1 | Tacho (Injection feed) | |
| 2 | Tacho (Carb Feed) | |
| 3 | Contant Live Via Fuse 8 | |
| 4 | Oil Level (Pin 2) | |
| 5 | Oil Level (Pin 1) | |
| 6 | Choke Light | - |
| 7 | ECU Light | - |
| 8 | 4×4 Light (not UKDM) | |
Blue Connector 7 Pin
| Pin | Function | Switched |
|---|---|---|
| 1 | Brake Wear Sensor Feed 1) | |
| 2 | Brake Pad Wear | - |
| 3 | Low Radiator | - |
| 4 | Alt Charging | - |
| 5 | Switched Live (2/3 Click) | |
| 6 | Fuel Guage | |
| 7 | Low Fuel Light | - |
Brown Connector 6 Pin
| Pin | Function | Switched |
|---|---|---|
| 1 | Switched Live (3/4 Click) | |
| 2 | Low Fuel Light | - |
| 3 | Fuel Guage | |
| 4 | Not Connected | |
| 5 | Oil Temperature | |
| 6 | Ground | |
1)
From Brake switch on pedal
ax_clocks_pinout.txt · Last modified: 2016/08/18 20:27 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
